If you have noticed that there are already tiles in your home that are coming loose, the best thing that you can do about this is to repair is sooner than later as this will enable you to save some amount yourself. And also, there goes the fact that if you just left the tiles that are coming loose as is, there is a big possibility of it coming off and breaking and you know how dangerous it is to let shards of broken tiles to lie on the floor since people may trip over it and eventually get injured. Know that there are so many ways on how you can deal with tiles that are coming loose and some of which are a whole lot better than the others.
One of the ways on how you can handle tiles that are coming loose is by means of pulling them all up and replacing them. But then again, the downside of replacing all the tiles that are coming loose is that it is not only expensive, there goes the fact that it can be messy and time consuming as well. When the problem that you have only deals with several pieces of tiles that are coming loose, replacement is not necessary to be taken as this can be fixed by tile repair alone.
Now, with regards to tile repair, there are quite a number of things that you have to take into account like the need for you to clean them by using a household cleaner. If you have already cleaned the tiles and make it as spotless as you can, what you should do next is to put the special ceramic glue onto the areas where the cracks are present. After placing the special ceramic glue to the damaged area, you can use a knife to force the damaged tile to stick to the floor, not to mention that you can also use it to smoothen the damaged area too. Once you have placed the damaged tile again to the floor, you must not move it from one place to another since you have to let the glue work for twenty four hours.
After the time limit or the twenty four hours have passed by, what you should do next is to sand the dried glue using a sandpaper so that the rough edges or the rough texture will turn smooth and soft. You have to continue sanding down the dried glue until you achieve an area that is completely flat. Of course, this will not be made possible if you are rough with your movements hence, make sure that you are doing it with light and quick strokes.